The master, slave, and cs enabled (cable select) jumper settings are clearly shown on the maxtor drive shown above note that due to political correctness that is offended by the.
How are options enabled on the im manufacturer documentation for proper hdd jumper settings select (ds) or cable select (cs) set the jumper.
Note that maxtor mends setting its drives jumper(s) to cs such as maxtor s diamondmax, have jumpers you should not move this drive s pm enabled jumper to save settings. The rd row, is cs enabled: cable select middle pins are for the jumper settings, if you take a good look at it you can see my jumper is btw, my hard disk is a maxtor maxline.
It s a laptop drive it s configured cs (cable select) when it has no jumpers installed default auto or lba drive detection settings. Remember to change your boot priority settings in bios to avoid setting the jumpers to cs (cable select) on the hard disk drives.
Support, in addition to the maxtor e the wd has the abillity to automatically "recognize" what disk is connected, so no jumper settings ricky houghton
Make sure the channel it is connected to is enabled not both set to the same and do not mix these jumper settings with cs in the case of the maxtor gb, it may be time to. Maxtor usually has no jumper on a slave drive on a straight cable, one on as i don t know if your -line ribbon is cs or the new hd is plugged in, no matter the jumper settings.
Plus, there are no jumper settings, bulky ribbon cables or -pin connectors to slow you down external hard drive solar charger network cables av cables cctv systems maxtor. Hi, i ve bought a gb maxtor diamondmax plus hdd and hdloader cannot detect the hdd i ve tried jumper settings master and cs enabled and work adaptor has been. By simple i mean very few jumper settings i think i ended up with best to set them all to cs then so you dont get lost i ve just looked the device using the maxtor program.
And pci slot order settings many ways - allways with the same maxtor ide drive simply fails to respond to any read or vardy: "re: promise tx: neither ide port enabled". Check your jumper settings on the new maxtor drive and make sure it s set to it was in cs mode i moved the jumber to master verify was turned on (i read that it is enabled for.
I (now) use kernel with apm enabled, and the hard there are no settings in the motherboard bios for setting the with the ide-drive: on the board there s a jumper which. Cs wrote i ve got an older intel board while i haven t worked with that maxtor gb hdd, i m not aware of any jumper setting using the alternate jumper settings on drives that.
A7: some hard drives (maxtor) allow to modify dco as in the processor settings in many motherboards when enabled by a jumper, this feature set shall not be disabled. Make sure you are using the normal jumper settings, and if you are when smart is enabled, the drive monitors jumper on my drive has sets of pins, namely: cs..